Chlorine and its cousin, chloramine are toxic for fish. You must eliminate chlorine for fish safety. These deadly compounds oxidize and literally burn organic material on contact surfaces. Either immediately damaging tender membranes such as gills when they come in contact with both chemical. The best way to prevent this disaster is to always ensure no connection at all has the opportunity to contact at all the fish in any way. Since chlorine through the water treatment business is done - before it is delivered to your tap, simply dumping water in a new aquarium set up is a recipe for disaster.
Never, never, never do that! The best and highly recommended method is to remove the chlorine before it even have a chance to have come in contact with the aquarium itself. This means that the best place to neutralize it in the transport method between tap and tank. This really is not much of a problem because new water is transported usually with a bucket. Since the chemical reaction between the active ingredient of most water conditioners and chlorine remover works instantly, so there is no danger of any chlorine in the aquarium if you just treat the new water when it is in the transportation bucket.
We recommend the following procedure to safely remove chlorine when replacing evaporated water, or the water is removed during a partial water change. The absolute safest way to do this is:
1) Perform for a minute or so, so that no metal ions deposited in standing water flushed down the drain of metal pipes before the water begins to fill the bucket. Tap the
2) At this point it is advisable to reduce the temperature as close as possible to each of the aquarium temperature thermal shock and to regulate.
Brought 3) When the bucket is in position to be filled, the filling of the dose corresponding to the amount of water as the tank. This ensure the water is completely mixed into the chlorine remover fills the bucket.
4) conveying the water in the tank into the container by the water treatment in the bucket as it begins to fill, there is no possibility that it is not completely mixed with the new tap water. It is safe and ready to fish when you pour it into the tank.
To be honest, we are always very liberal with the dosage, double the dosage is not cause damage, or a moment's hesitation, and ensures that the chlorine, even if the water company will be added to many additional, not to to harm the fish. Most of the water purifier also have many additional features that are meant to help the fish with the stress and hazardous metals. Such as bacteria and plants, these are made available in quantities where they can not harm the fish or the other inhabitants of the aquarium. Rather, these additives ensure that they continue to thrive over time. Tests for some of the products have shown that the products are safe for fish at 100 × dose!
Never use less than recommended dose, but if you end up overdosing something, do not worry. It does not hurt us and prevents serious problems from happening. I never add untreated tap water to an established tank. Although the water treatment has been placed directly in the tank, typically, the dose for the replacement volume. In addition, there may be a slight lapse between the chlorine hits the Aquarium and the neutralization finishing his. If at all possible treat in the bucket, never directly into the tank. This reduces the risk of unseen damage to gills, which can cause serious health problems in later life of the fish.
Thank you for coming in Exotic of Pets and read the article about: Safely Remove Chlorine - Tip 7 in the Water Series , help us to Shared this article. hopefully useful to us all.
